VICTORY ONLY CUSTOM MOTORCYCLE ACCESSORIES

Lowers the rear of the bike 3 inches. Pictured below on my 2009 Victory Vegas in Pearl white. I installed this kit on my bike to give it a custom look and make the bike sit low. It didn't change the ride much if any. It installs pretty easy but is well worth the time for looks alone. These mounts replace the stock spacers and just bolt up.
--------------------------------------------------------------------------------

3 inch lowering kits may require modifications to be done to the following parts for proper operation

1. front of belt guard shortened 1/8-1/4 inch so it does not rub on front sprocket cover

2. front sprocket cover may require removing cast in 3/16 cast edge on the inside of cover. This is easily done by removing front sprocket cover and using a small grinder to remove cast in edge.

3. Belt adjustment will also be necessary. Adjustment can vary but usually is 1-3 turns on the belt adjust screws. Please consult the factory manual or your local dealer before any adjustment is made.

4. Adjustment of shock spring may be necessary to achieve desired ride quality. The shock spring can be adjusted by tightening the upper spring perch adjustment. This will require the use of the correct spanner wrench or adjustable spanner wrench. Consult your local victory dealer or local motorcycle shop for these tools


BELT COVER LOW KIT	1 INCH LOWERING KIT	2 INCH PEG EXTENSION	BELT COVER AND LOW KIT