Tools Suggested
Metric wrenches, sockets and related hand tools, soldering iron and related
wiring tools.
Note
While installation is rather straightforward, dealer installation is recommended
for those individuals not comfortable with wiring and other related skills required
for the installation of this product.
Please note that the flash rate will vary from bike to bike based on the bike's
total electrical load impedance, and can be modified with the installation of a
flasher module (not included). As stated in our conditions page @
www.mbwmotorcycle.com, this is not an acceptable reason for refund/return.
PROCEDURE Average Time: 1-1½ HOURS
· Prior to install if you'd like to test each LED, simple hold the correct wires
to the corresponding terminals on the battery or other 12 volt source.
· Prior to hard wiring/soldering it is recommend that you mock-up
the wiring to determine your flash rate and four-way flasher
function to determine whether or not a flasher module is needed
or desired.
· Remove front turn signals
· Expose the wiring to allow you to set up and splice and solder the wires
accordingly.
· Be advised that is extremely likely that your bike’s right front turn signal
was incorrectly wired with reverse polarity. If your LEDs don’t light when
wired correctly, simply switch them and wire the LEDs hot wire to the
stock black/ground wire and vice versa.
· Use the stock wire sheathing to run the wires from the turn signals up into
the headlight bucket. Be careful to run the wires in a manner that will
avoid them being pinched when the handlebars are turned.
Vegas/8-Ball/Jackpot
Front LED Bracket-Style Turn Signal
Installation Guide
· Your front turn signal wires can be run in one of two ways…wires can be
run along the inside channel towards the back of your lower triple tree
and up into the stock wiring, or…You can drop the wire down through the
small hole on the inside bend of the turn signal arms and run the wires on
the outside of the lower triple tree.
· Once all your wires are set up in the bucket, splice and solder your flasher
module (if applicable) in with the stock wiring and LED turn signal wiring.
Please note that the flasher module can be installed in place of
the factory flasher relay at any time during or after the
installation of the front LED turn signals and does not require
any duplication or reversal of prior install work.
· Remove the headlight bucket mounting nut and loosen and/or remove the
front brake line retaining bolts (applicable on the ’03 Vegas) and slide the
turn signal bracket between the brake line and lower triple tree.
· Replace the headlight bucket mounting nut while maintaining proper
headlight and turn signal bracket alignment and tighten. Do the same
with the brake line retaining bolts.
· Once testing and function check is complete, reinstall headlight and
double check any nuts/bolts for proper reinstallation prior to riding.
· You’re done, what are you waiting for…
Time to ride…