1. Certified victory motorcycle mechanic should do all part installations.

 

2. Remove forward socket head cap screw from foot control mount on right side.

 

3. Partially remove reward socket head cap screw, this will allow the foot control bracket to rotate down.

 

4. Now install tomahawk victory Vegas rear brake master cylinder cover. The master cylinder cover will bolt in-between the frame and foot control bracket It may be necessary to re-index the brake master banjo fitting and resvoir line.

 

5. Mark using a pen or paint marker where the resvoir line to the master cylinder will contact tomahawk Vegas master cylinder cover.

 

6. Remove Tomahawk master cylinder cover and then wrap master cylinder reservoir line with the red silicone anti chafe tape. This tape only will adhere to itself so wrap around line and make sure it contacts.

 

7. Now take the Teflon strip of of anti chafe tape (white) and install it on the foot control where the edge of the Tomahawk master cylinder cover contacts the foot control bracket. Trim as necessary.

 

8. Now reinstall Tomahawk master cylinder cover. Install forward socket head cap screw first.

 

9. Use the 2 zinc flat washers supplied to space out rear foot control socket head cap screw. The washer is needed to compensate for the Tomahawk master cylinder covers mounting plate.

 

10. Make sure all fasteners have loctitie 242 on them prior to reinstalling them. Make sure rear brakes function correctly prior to operation of motorcycle, and that all lines are clear of any possibable hazards.

 

11. TOMAHAWK REAR MASTER CYLINDER COVER IS FOR OFFROAD USE ONLY.